UP Plus 2 platform heater FFC cable.

This cable is to replace the X axis FFC cable that supplies current to the platform heater PCB.

Please see the image above and select the correct kit that matches your UP PLUS 3d printers platform heater setup.

1. Remove the black table (2 screws)  (refer to image above)
2. Remove the front two screws on the X axis arm
3. Remove the back right hand side screw on the X axis arm
4. Then lift off the X axis cover
5. Take a look which version cable you have as compared to the photo above.
6. Remove the base cover of the printer, two screws on either side and see what version motherboard you have.
7. If there is damage or you are unsure, please email a photo to support@3dprintingsystems.com